Shop replacement repair parts for Payne Furnace model PG8UAA060155ABJA

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Furnace draft inducer motor with cooling fan. Be aware that the screw holes are not threaded—you will need to use self-tapping screws to install the motor.

Limit switch

Furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Transformer, 120V-24V 40VA

Igniter replacement kit

Pressure switch

Gas valve kit. *Should be installed by a certified Carrier repairperson.

Carrier furnace blower motor. This single-phase motor has the following specifications:
Horsepower: ¾
Voltage: 115
FLA (full load amps): 11.1
RPM: 1075
Speeds: 4
Rotation: CCW
Frame: 48
Shaft Length: 4”

Limit switch, 160 degree

Relay pilot dty

140f m/r limit switch, hh12ha142

Blower housing asy

Main wiring harness

Wiring harness