Shop replacement repair parts for Trane Furnace model CUC040A924A0

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

HSI control module with four wire leads The HSIcontrol module regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Flame rollout switch. Push red button to reset. L310

Hot surface furnace ignitor with plug on connector

Transformer; 115v pri, 24v sec., 60hz, 35va, foot mount

Capacitor; run, 7.5 mfd, 440v oval, w/o resistor

Thermal limit switch, open at 230F, close at 200F.

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Wiring, replacement harnes

Wire; ignition harness

Inducer limit switch replacement kit

Valve; gas, 1-stage, fast open, toggle switch, no b

Motor; 1/5 hp, 115/60/1, 1080rpm,48frm,type psc, sl