Shop replacement repair parts for Trane Furnace model TDD140R960E0

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Flame rollout switch. Push red button to reset. L310

Hot Surface Ignitor Kit

Transformer; 115v pri, 24v sec., 60hz, 35va, foot mount

Furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Blower motor, 3/4HP, 115 volts, 60 hertz, 9.6 amps 1075 RPM's, 4 Speed Open Enclosure, 48Y Frame, Single Phase CCW 3" Shaft

Wire; replacement ignitor wire harness

Switch; high temperature limit, open at 120 degrees

Blower housing assembly

Wire; replacement wiring harness asm

Valve; gas, 2-stage, toggle switch, no barb. when u

Capacitor; run, 15 mfd, 370vac, oval, w/o resistor

Blower; induced draft, 2 stage, 3000 rpm, 1.4 amps,