Shop replacement repair parts for Trane Furnace model TUH1B080A9H31CA

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Hot Surface Ignitor Kit

Thermal limit switch, open at 180 degrees, close at 150 degrees

Switch; switch-flame rollout, 82 degrees c, 180 deg

Switch, pressure, open at -1.51 wc, close at -1.73

Intergrated furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Switch; limit inducer

Draft inducer motor, one stage, ball bearing.The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Wire; harness assembly, including inducer/ignitor h

Wire harness assembly, includes inducer/ignitor harness with 4 pin male connector and control harness with 12 pin male connector.

Valve; gas, fast opening 1/2-14 npt, 24v, 50/60 hz,

Pressure Switch .76 set point, spdt normally open

Motor; constant torque, 1/2 hp, 115/60/1, 1050-600

Housing; blower

Transformer; 115v-pri 24v-sec 35va