Sub Zero 690 Refrigerator Parts

Maintain the preservation performance of your Sub Zero 690 with genuine OEM replacement parts from Repair Clinic. The Model 690 is a 600 series built-in side-by-side refrigerator and freezer with through-the-door ice and water dispensing. Parts replaced most often include the 690 ice maker, the water inlet valve, the evaporator fan motor, and the door gasket. Find your part on the 690 parts list, then browse all Sub Zero refrigerator parts.

What the Dispenser Adds to 690 Service

The dispenser is what sets this model apart from non-dispenser 600 series side-by-sides like the Sub Zero 642. It adds a water line through the door, a dispenser valve circuit, and controls that are not found on those models, so water problems on this 690 refrigerator have more possible causes. Check the supply, filter, and inlet valve before replacing the ice maker. Temperature problems usually show up on one side first; isolate that compartment and check its fan and door seal before any compressor work. The 690 manual and 690 diagram show valve and fan positions. For 690 repair steps, open the model troubleshooting page.

Most Replaced 690 Refrigerator Parts

Ice Maker and Dispenser

If ice stops but water dispenses, the water path is working and the ice maker or freezer temperature is the issue. If neither works, check the supply and valve first. Replace the ice maker only after water reaches it.

Water Inlet Valve

The 690 water inlet valve feeds both the dispenser and the ice maker. Test each solenoid for continuity; one failed coil stops one outlet while the other works. Shop valves here.

Evaporator Fan Motor

When the 690 evaporator fan motor fails, that compartment warms while the compressor runs. No fan sound during cooling confirms the failure. Replace the fan motor for the warm side.

Door Gasket

The 690 door gasket on the dispenser door works around the dispenser housing and wears at the lower corners first. Run the paper-drag test and replace the gasket where it fails.

Why Choose Repair Clinic for 690 Dispenser Refrigerator Parts

• Genuine Sub Zero OEM Parts: Factory components for the 600 series side-by-side with dispensing. Browse all Sub Zero refrigerator parts.
• Dispenser-Specific Listings: Dispenser valves and door water parts are listed for this model, not borrowed from non-dispenser units.
• Valve Before Ice Maker: Each inlet valve coil is tested before an ice maker is ordered.
• Shop 690 Parts Online: In-stock 690 replacement parts and 690 refrigerator parts ship the same day with a 365-day return policy.

Sub Zero 690 FAQ

Why is my 690 not making ice?

Check the water supply, filter, and freezer temperature, then test the inlet valve coils. Replace the ice maker only if water reaches it and it still will not cycle.

Why does water dispense but no ice is made?

The water path is working, so focus on the ice maker and freezer temperature rather than the inlet valve.

Why is one side not cooling evenly?

Check that side’s evaporator fan, defrost system, and door gasket. A problem on only one side is rarely a compressor failure.

How is the 690 different from the 642?

Both are 600 series side-by-sides, but the 690 adds through-the-door ice and water dispensing, which brings its own valves and controls, so many 690 parts differ.