Shop replacement repair parts for KitchenAid Dryer model KGYE960WAL0

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Dryer drum drive motor with pulley

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

This is a genuine replacement part. Whirlpool 349639 Lint Screen.

Moisture sensor kit

Gas valve assembly with two & three terminal coils

Outside Sensor bar

Sensing bar on blower housing

Replacement gas burner and igniter kit