Shop replacement repair parts for Bosch Dishwasher model SHU66C05

The Bosch Door Seal 00494772 is a genuine OEM part that seals the gap between the dishwasher tub and the outer edge of the door. It is compatible with various dishwasher models and can be installed without tools.

The Bosch Water Inlet Valve 00425458 is a high quality OEM part that supplies water to the dishwasher. It has a single water in-flow and out-flow port and is compatible with various Bosch, Kenmore, and Thermador dishwasher models. Safety precautions should be taken during installation.

The Bosch Tine Row Clip 00418498 is a high-quality OEM part used in the lower rack of a dishwasher to hold the tine row in place. It allows for the conversion of the rack to accommodate more dishes of different shapes and sizes.

The Bosch Drain Hose 00298564 is a genuine OEM part that carries drain water from the dishwasher to the kitchen sink drain. It is 5 ft. in length and comes with one O-ring. The hose is compatible with various Bosch dishwasher models and replaces several part numbers.

Dishwasher lower dishrack assembly with wheels. Corroded or rusted dishracks should be replaced to avoid parts of the rack falling down and getting into the circulation pump damaging the pump.

Hinge Bushing Snap Lock

The Bosch Dishrack Roller 00165314 is a genuine OEM part that attaches directly to the rack and allows the lower rack to roll in and out of the dishwasher with ease. Sold individually. Recommended to replace in pairs due to wear and tear. The roller has a diameter of approximately 1.5 inches.

Tine clip kit (also called a bearing) for dishwasher dishrack. Includes (2) bearings (2) sleeves and (4) tine clips.

The 00419827 Door Latch Assembly is a genuine Bosch OEM replacement part for Dishwashers that keeps the door closed during operation. It includes a long strikeplate and does not come with a microswitch. Verify the correct part number with the appliance service manual or manufacturer.

Door support rope and pulley kit

The Bosch Float Switch 00165256 is an OEM part that shuts off the water fill valve if the water level gets too high before the fill cycle ends. Compatible with many Bosch, Gaggenau, Thermador, and Kenmore brand dishwashers. Replaces several part numbers. Take safety precautions during installation.

The Bosch Upper Dishrack Slide Rail Stop 00165254 is a high quality, genuine OEM part that prevents the upper dishrack from sliding completely off the slide rail. It includes front and rear rack stops and is compatible with various Bosch dishwasher models.

The Bosch 00172272 Hose Clamp is a replacement part for Dishwashers that holds the water hose in place to prevent leaks. It has an inner diameter of 28mm-39mm

Microfilter basket assembly. Filters the water before going thru the pumps. Removed and installs easily by hand.

The Genuine OEM Bosch Screw 00151703 is a high-quality replacement for the inner door panel of various Bosch dishwasher models. It comes with six screws and replaces multiple part numbers. Safety precautions should be taken during installation.