LG Washing Machine WM2487HWM Parts

Washing machine water inlet and dispenser valve assembly. If the washer does not fill properly the valve may be resticted and need replacement. We do not recommend taking inlet valves apart and trying to clean them due to the risk of failure after repair.

Water level pressure switch

Manual drain tube, drain pump

Dispenser drawer housing

Clamp

Circulation or drain pump motor & impeller. This pump is found on both washing machines and dishwashers. On washing machines, this pump is used to circulate the water. On dishwashers, it is used to drain water from the dishwasher.

Washing machine door boot clamp for front panel.

Holder

Washing machine rear drum support and shaft assembly (also called a spider).

Drain port hose, curved to the right side

Thermistor temperature sensor. Works in conjunction with the main control board to monitor the water temperature.

Door boot seal (or door gasket) with drain port. If the washer is leaking, the door boot may be torn. Door boots are commonly torn as a result of overloading the washer.

Heating element with sensor probe. Element has been changed. May require new wire harness to install. Please see related item.

Washing machine rear outer tub assembly with bearings. If the tub bearing system is defective the washer can become very noisy.

Front drum cover WITH drain port. *Original front drum cover did not have drain port. If cover is being used on a machine that did not have a drain port it will need to be plugged or Related Items below will be needed.