Shop replacement repair parts for Whirlpool Dryer model WGD6400SW1

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

High-limit thermostat kit. Contains hi limit thermostat and thermal cut out fuse. If the dryer overheats, the high-limit thermostat cuts off power to the dryer. If the dryer won't heat, the high-limit thermostat may have blown. This part has been updated by the manufacturer and may look different.

Idler pulley assembly for dryer drum drive belt

Dryer drum drive belt. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Dryer drum drive motor

Dryer door switch kit

Panel

Panel

Belt switch and harness

Control knob, white

Console

Electronic control board assembly. NOTE: This part is often misdiagnosed and requires electrical testing with a volt/ohm meter to determine if it is defective.

Panel

Control panel