Price Match GuaranteeKenmore Dryer 110.67072600 Parts
Shop replacement repair parts for Kenmore Dryer model 110.67072600
Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.
Dryness sensor bar
Dryer heating element wire connector kit. Wire with spade terminal & wire nut
Dryer door catch. If the dryer door does not latch closed then the door strike or this catch is likely damaged
Dryer idler wheel and bracket assembly. Provides tension to the dryer drum belt.
Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.
White Touch Up Paint
Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.
Dryer front panel retainer clip. 1 clip per pack.
Shaft for dryer drum support roller. Front shaft with right hand threads. Part is updated so nuts may need to be replaced as well on older dryers.
Screw, 10-24 3/8
Spring for idler pulley arm in dryer
Dryer vent testing kit is for 29" dryers with a top mounted lint screen. Use the plastic card to hang inside your dryer drum, then run the unit three times empty. If the card stays in place, the venting and dryer need to be cleaned out. Complete instructions are included.
Terminal block for power cord. Block only
Screw, 10-16 x 7/8
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic