Price Match GuaranteeGE Dryer DCVH660GH1MB Parts
Shop replacement repair parts for GE Dryer model DCVH660GH1MB
Gas dryer igniter assembly with bracket and wire harness. If the dryer does not heat then the igniter may have burned out. The burned spot is normally visible. Be aware the igniter is very fragile.
Dryer center outlet thermistor. *Note that it is not in the heating circuit so it likely will not be the cause of a dryer heating problem. It can however effect cycle times or cause a fault if defective. The resistence reading should read around 100 k ohms at room temperature.
Inlet control thermistor. Resistence reading should be around 100K ohms at room temperature and decrease with temperature rise.
Dryer gas valve solenoid coil. Has two terminals.
Thermostat, high limit
Gas valve solenoid coil 3 terminal
Flame sensor at side of burner tube
The GE Appliances Backup Thermostat regulates heat in dryers if the control system fails. It replaces multiple part numbers and caution should be taken when servicing or repairing appliances. Consult the owner's manual for instructions and safety measures.
Main power board assembly, gas
Motor and pulley assembly
RC Item #1264211
Gas valve and supply pipe assembly, Natural gas
Sensor harness
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic