GE Dryer DCVH680EJ2MR Parts

If your clothes dryer drum doesn't turn when the dryer is on, you likely need the Drive Belt WE03X29897, which is 89-1/2 inches long with four ribs. This genuine OEM replacement part is compatible with Whirlpool, Kenmore, GE, Hotpoint, and RCA dryers and washer/dryer combos.

Dryer idler pulley wheel. If the pulley wheel is worn down, it may cause the dryer to be excessively noisy.

High-limit thermostat for dryer. L315-65. If the dryer overheats, this high-limit thermostat will cut off the power to the drive motor. If the high-limit thermostat has blown, the dryer won't start.

Door switch

All purpose switch. Commonly used as dishwasher door switch, dryer door or broken belt switch, oven door latch switch and more

Dryer center outlet thermistor. *Note that it is not in the heating circuit so it likely will not be the cause of a dryer heating problem. It can however effect cycle times or cause a fault if defective. The resistence reading should read around 100 k ohms at room temperature.

Mica heater unit

Inlet control thermistor. Resistence reading should be around 100K ohms at room temperature and decrease with temperature rise.

This is a Genuine Replacement Part. General Electric (GENF0) WE4M160 High Limit Thermostat.

Dryer heating element assembly. If the dryer won't heat, first check the thermal fuse to determine if has blown. If the thermal fuse has not blown, the heating element might be defective. The heating element will often have a break in the coil if it is defective.

Motor and pulley assembly

Main power control board assembly

Control panel asm bb

Knob And Insert Assembly

User interface control board assembly