GE Dryer GFDN245EL0BB Parts

If your clothes dryer drum doesn't turn when the dryer is on, you likely need the Drive Belt WE03X29897, which is 89-1/2 inches long with four ribs. This genuine OEM replacement part is compatible with Whirlpool, Kenmore, GE, Hotpoint, and RCA dryers and washer/dryer combos.

Dryer drum slide. There are two of these needed on your dryer. These go on the outer most slots on the front bearing. Sold as pack of two. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Dryer drum slide (2 pack). There are two of these needed on your dryer. These go on the inner most slots on the front bearing. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Rear drum bearing sleeve

Dryer idler pulley wheel. If the pulley wheel is worn down, it may cause the dryer to be excessively noisy.

Light bulb, 120V, 10W

Drum support shaft and bearing assembly

6 Foot 30 Amp 3 wire dryer cord

All purpose switch. Commonly used as dishwasher door switch, dryer door or broken belt switch, oven door latch switch and more

High-limit thermostat for dryer. L315-65. If the dryer overheats, this high-limit thermostat will cut off the power to the drive motor. If the high-limit thermostat has blown, the dryer won't start.

Door switch

Mica heater unit

Dryer center outlet thermistor. *Note that it is not in the heating circuit so it likely will not be the cause of a dryer heating problem. It can however effect cycle times or cause a fault if defective. The resistence reading should read around 100 k ohms at room temperature.

Inlet control thermistor. Resistence reading should be around 100K ohms at room temperature and decrease with temperature rise.

Dryer drum drive motor and pulley. Wiring Harness Is Encased In The Styrofoam Inside The Box