LG Washing Machine WM2101HW Parts

The 4681EA2001T Washing Machine Drain Pump and Motor Assembly is a genuine OEM replacement part that expels water from your washing machine or washer/dryer combo. This high-quality component ensures proper drainage. It's compatible with Kenmore, LG, and Kenmore Elite models.

Washer cold water inlet valve assembly. Three solenoids. Hot water valve is a separate single coil valve and can be found in related parts

Washer hot water inlet valve. Standard hose fitting inlet, 1 water outlet. The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all.

Washing machine door boot gasket with drain port. If the door boot is torn, the washer will leak water. The most common cause of a torn door boot is if the washer is overloaded. Be aware that your model may also list a door boot without drain port. Be sure to check the original part before ordering.

Washing machine tub seal between outer & inner tubs

Washing machine drain hose. If the drain hose is cracked, it will leak water during the washer's drain cycle.

Washing machine tub seal. Located between the front outer tub and rear outer tub. If the washing machine is leaking water from between these two tubs, this seal is likely damaged or worn out.

Washing machine drain hose with bellows. This drain hose makes a connection from the washer tub to the drain pump.

Washing machine door boot clamp for front panel.

Drain port hose, curved to the right side

Clamp assembly

Outer tub vent tube (bellows)

Washing machine water supply hose with 90' elbow

Water supply hose. 5 feet long

Washing machine water supply hose. 5 feet long with 90 degree connector on one end