LG Washing Machine WM2501HVA Parts

The 4681EA2001T Washing Machine Drain Pump and Motor Assembly is a genuine OEM replacement part that expels water from your washing machine or washer/dryer combo. This high-quality component ensures proper drainage. It's compatible with Kenmore, LG, and Kenmore Elite models.

Washer hot water inlet valve. Standard hose fitting inlet, 1 water outlet. The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all.

Washing machine tub seal between outer & inner tubs

Washing machine drain hose. If the drain hose is cracked, it will leak water during the washer's drain cycle.

Washing machine tub seal. Located between the front outer tub and rear outer tub. If the washing machine is leaking water from between these two tubs, this seal is likely damaged or worn out.

Washing machine water inlet and dispenser valve assembly. If the washer does not fill properly the valve may be resticted and need replacement. We do not recommend taking inlet valves apart and trying to clean them due to the risk of failure after repair.

Washing machine drain hose with bellows. This drain hose makes a connection from the washer tub to the drain pump.

Washing machine door boot clamp for front panel.

Circulation or drain pump motor & impeller. This pump is found on both washing machines and dishwashers. On washing machines, this pump is used to circulate the water. On dishwashers, it is used to drain water from the dishwasher.

Drain port hose, curved to the right side

Door boot seal (or door gasket) with drain port. If the washer is leaking, the door boot may be torn. Door boots are commonly torn as a result of overloading the washer.

Clamp assembly

Outer tub vent tube (bellows)

Washing machine water supply hose with 90' elbow

Water supply hose. 5 feet long