Shop replacement repair parts for Maytag Dryer model GDG19CT

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

Dryer drum drive motor. New style motor switch, The motor will need re-wiring.
Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all

Adjustable dryer cycling thermostat kit L135-155. The cycling thermostat cycles the heat on and off to regulate the air temperature. If the cycling thermostat is defective, the dryer will not heat. To determine if the thermostat is defective, use a multimeter to test it for continuity.

This is a Genuine Replacement Part. Whirlpool (WHIRA) 33303391 Thermostat - Replacement.

Cntrl-elec

High limit thermostat, L240-40F

Booster coil kit for gas valve, used with holding coil

Holding coil kit for gas valve, used with booster coil

Circuit board

Gas valve solenoid kit

Primary coil kit for gas valve, used with holding coil #1213, and booster coil #2232

New style 2 coil gas valve conversion kit *Please call with serial number to verify correct part

Timer

Cycling thermostat, L135-15F