Maytag Dryer LDE1000ACE Parts

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer thermal fuse and high limit thermostat kit for both gas and electric models. If the dryer does not heat then the thermal fuse may have blown and will need to be replaced.

Heating element assembly with replacement high limit thermostat, L248-80 (240 Volt, 4750 Watt). Dryer Heating element. If the dryer does not heat check for a blown thermal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.

Dryer drum drive motor assembly. If the dryer does not start the motor could be bad. Before replacing the motor the door switch and thermal fuse should be tested to determine if they are defective.

Control thermostat, L146-25F, 240 Volt internal heater

High limit thermostat, L248-80F

The Whirlpool Burner Igniter WP31001556 is a high-quality replacement part for dryers that lights the gas burner to heat the dryer during the cycle. It replaces several other part numbers. Disconnect the appliance from all utilities prior to installation.

Drum drive motor 230v 60hz

Thrmst-fix

Timer

Control thermostat, L146-25F, 120 Volt internal heater

Heating element, 3750 watts

Thermostat kit, L120-10F

Timer assembly