Shop replacement repair parts for Maytag Dryer model LDG5005AAE

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

Dryer drum drive motor. New style motor switch, The motor will need re-wiring.
Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all

Dryer high-limit thermostat, L220-40F. If the dryer overheats, this high-limit thermostat will cut off the power to the heating element. If the high-limit thermostat has blown, the dryer won't heat.

Thermal fuse

High-limit thermostat L200-30

This is a Genuine Replacement Part ,The Model Number and Name for the Following Item: Whirlpool (WHIRA) 279950 Element, Heater Sam (240V).

This is a genuine replacement part. Whirlpool 307473 Thermal Fuse.

Cycling thermostat, L140-20F, three wire

Gas valve assembly

Heating element assembly for electric dryer, *without thermal fuse and heat shield series A3

Harness- w

Harness- w

Harness- w