Shop replacement repair parts for Kenmore Dryer model 110.77042601

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

High-limit thermostat kit. Contains hi limit thermostat and thermal cut out fuse. If the dryer overheats, the high-limit thermostat cuts off power to the dryer. If the dryer won't heat, the high-limit thermostat may have blown. This part has been updated by the manufacturer and may look different.

Dryer idler wheel and bracket assembly. Provides tension to the dryer drum belt.

Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.

Dryer drum drive belt Measures 95.19"

Thermal cutoff

Blower drive belt

Dryer drum drive motor

Knob

Broken belt switch & harness

Console

Dryer door switch with wire harness; *Note: This part is no longer available from the manufacturer, but replacements have been established that correspond to various models. Please contact us with your model number for a suitable replacement.

Control board

Electronic control board assembly. NOTE: This part is often misdiagnosed and requires electrical testing with a volt/ohm meter to determine if it is defective.