Shop replacement repair parts for Maytag Washer/Dryer Combo model LSG1000

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

Dryer high-limit thermostat, L220-40F. If the dryer overheats, this high-limit thermostat will cut off the power to the heating element. If the high-limit thermostat has blown, the dryer won't heat.

Thermal fuse

High-limit thermostat L200-30

1 Speed drive motor. Transfer pulley & motor mount from old to new

Dryer drum drive motor

High limit thermostat (some Canadian models only)

Heating coil

Heating element kit - 208 Volt

Gas valve assembly

Cycling thermostat, L150-10F

This is a Genuine Replacement Part ,The Model Number and Name for the Following Item: Whirlpool (WHIRA) 279923 Thermistor - Dryer.

Heating element assembly, 208 Volt