Maytag Washer/Dryer Combo MHW2000AWW Parts

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

Dryer drum drive motor. Includes pulley for dryer drum drive belt. Other shaft is D shaped with two slots for blower wheel snap rings. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all

Dryer high-limit thermostat, L220-40F. If the dryer overheats, this high-limit thermostat will cut off the power to the heating element. If the high-limit thermostat has blown, the dryer won't heat.

High-limit thermostat L200-30

Thermal Fuse

This is a genuine replacement part. Whirlpool 307473 Thermal Fuse.

Gas valve assembly

Dryer timer

This is a genuine replacement part. Whirlpool 12002039 Motor-Drive.

Heater asy

Heating element conversion assembly from 240 Volt to 208 Volt

Washing machine motor for the Neptune washer. Please call with model and serial number to verify correct part as the serial number is needed to verify that this is the correct part.