Shop replacement repair parts for Maytag Washer/Dryer Combo model MLG19PRAWW

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

Dryer drum drive motor. Includes pulley for dryer drum drive belt. Other shaft is D shaped with two slots for blower wheel snap rings. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all

Adjustable dryer cycling thermostat kit L135-155. The cycling thermostat cycles the heat on and off to regulate the air temperature. If the cycling thermostat is defective, the dryer will not heat. To determine if the thermostat is defective, use a multimeter to test it for continuity.

Thermal Fuse

Dryer burner igniter

Dryer drum drive motor. Includes pulley for dryer drum drive belt. Other shaft is threaded for blower wheel. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all

This is a Genuine Replacement Part. Whirlpool (WHIRA) 33303391 Thermostat - Replacement.

High limit thermostat, L240-40F

Gas valve assembly

This is a genuine replacement part. Whirlpool 12002039 Motor-Drive.

Frontload washer drive motor. *Please call with model and serial number to verify correct part.

Control board (Washer/Dryer Combo)

Washing machine motor for the Neptune washer. Please call with model and serial number to verify correct part as the serial number is needed to verify that this is the correct part.