Shop replacement repair parts for Maytag Dryer model MGD6400TQ0

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

Lint screen assembly

Dryer drum drive motor

Cntrl-elec

User interface

Gas valve

Electronic control board assembly. NOTE: This part is often misdiagnosed and requires electrical testing with a volt/ohm meter to determine if it is defective.

White lint screen cover

Sensor pad