Whirlpool/Kenmore Gas Dryer Replace Flame Sensor #338906

Print ContentSave Content

Skill Level

Total Parts Cost

$35.94

Estimated Savings

$112.50

03:54

Description

This video provides step-by-step repair instructions for replacing the flame sensor (or gas sensor) on a 27-inch Whirlpool/Kenmore gas dryer. The most common reason for replacing the flame sensor is when the dryer is not heating.

All of the information for this flame sensor replacement video is applicable to the following brands:
Kenmore, Whirlpool, Maytag, Amana, Speed Queen, KitchenAid, Roper, Norge, Crosley, Montgomery Ward

Tools needed: hex socket, flat head screwdriver, Phillips head screwdriver, putty knife

Step By Step Instructions

Print Instructions

As with any repair, be sure you unplug the appliance before beginning.

Your first step is to pull out the lint screen and remove the two screws near the opening.

Next, insert a putty knife under the front of the main top to release the two spring clips and rotate the top up.

Disconnect the door switch wires and remove the top front panel screws.

Now, lift the panel up and out. If your model has two front panels

Use a flathead screwdriver to release the clips above the lower panel to remove it.

Now, loosen the two screws at the bottom of the upper panel and lift the panel off.

Depress the pulley to release the belt tension and unthread the belt from the pulley and motor shaft.

Now use the belt to lift out the drum.

Disconnect the wires from the old sensor.

Remove the mounting screw and slide the old sensor out of the burner tube.

Install the new sensor

By inserting the tabbed end into the slot in the burner tube and securing with the mounting screw.

Reconnect the wires.

Now, replace the drum by aligning its rim on the two support rollers and loop the belt around the tension pulley and motor shaft in a “zig-zag” formation.

Rotate the drum to help align the belt.

You’re now ready to reinstall the front panel or panels.

If your model has a solid front panel, align the slots in the panel with the two retainer clips.

Line up the drum with the seal on the front panel and press the panel down until it locks into position.

If your model has two panels, align the slots in the upper panel with the screws while lining up the drum.

Tighten the screws and replace the lower panel by snapping it into position.

Now, reinstall the two screws on top and reconnect the door switch wires.

Rotate the main top back into place and press down on the front to secure the spring clips.

Install the two screws at the lint screen opening replace the lint screen and plug the appliance back in to make sure it’s functioning properly.

Description

Step-By-Step Instructions