Price Match Guarantee
In-stock parts ship the same day
365-Day Return Policy
Price Match GuaranteeGET PRO PRICING
Video & Articles: Appliance & Equipment RepairWhirlpool/Kenmore Gas Dryer Motor/Heat Relay #3405281
Whirlpool/Kenmore Gas Dryer Motor/Heat Relay #3405281
Skill Level
Total Parts Cost
$34.74Estimated Savings
$112.5001:39
- Description
This video provides step-by-step repair instructions for replacing the motor/heat relay on a Whirlpool/Kenmore 27-inch gas dryer. The most common reasons for replacing the motor/heat relay are when the dryer won’t heat or won’t run.
All of the information for this motor/heat relay replacement video is applicable to the following brands:
Whirlpool, Kenmore, Maytag
Tools needed: Phillips head screwdriver, putty knife
All of the information for this motor/heat relay replacement video is applicable to the following brands:
Whirlpool, Kenmore, Maytag
Tools needed: Phillips head screwdriver, putty knife
Step By Step Instructions
1
As with any repair, be sure you unplug the appliance before beginning.
2
Your first step is to detach the control panel.
3
Depending on your model, you will either insert a putty knife under the panel to release the two clips or you will pull off both plastic end caps and remove the screws found underneath.
4
Now, rotate the control panel up.
5
Remove the mounting screws on the relay that you wish to replace.
6
Disconnect the wires.
7
You’re now ready to install the new motor/heat relay.
8
Reconnect the wires then insert the relay into the control panel and secure it with the screws.
9
Rotate the control panel back down, and snap it into place.
10
If applicable, replace the screws and end caps.
11
Now, plug the appliance back in to make sure it’s functioning properly.
Description
This video provides step-by-step repair instructions for replacing the motor/heat relay on a Whirlpool/Kenmore 27-inch gas dryer. The most common reasons for replacing the motor/heat relay are when the dryer won’t heat or won’t run.
All of the information for this motor/heat relay replacement video is applicable to the following brands:
Whirlpool, Kenmore, Maytag
Tools needed: Phillips head screwdriver, putty knife
All of the information for this motor/heat relay replacement video is applicable to the following brands:
Whirlpool, Kenmore, Maytag
Tools needed: Phillips head screwdriver, putty knife
Step-By-Step Instructions
1
As with any repair, be sure you unplug the appliance before beginning.
2
Your first step is to detach the control panel.
3
Depending on your model, you will either insert a putty knife under the panel to release the two clips or you will pull off both plastic end caps and remove the screws found underneath.
4
Now, rotate the control panel up.
5
Remove the mounting screws on the relay that you wish to replace.
6
Disconnect the wires.
7
You’re now ready to install the new motor/heat relay.
8
Reconnect the wires then insert the relay into the control panel and secure it with the screws.
9
Rotate the control panel back down, and snap it into place.
10
If applicable, replace the screws and end caps.
11
Now, plug the appliance back in to make sure it’s functioning properly.
Applicable Product Model
Parts Needed
Relay
$34.74
Total$0.00
Related Articles & Videos
Our Story
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic
© 2026 RepairClinic.com