DescriptionThis video provides step-by-step instructions for replacing the inner door glass on a Kitchenaid electric slide-in range (model #KSEB900ESS2). The most common reason for replacing the glass is if it is damaged or dirty.
All of the information in this glass replacement video is applicable to the following brands: Maytag, Amana, Magic Chef, Whirlpool, Tappan, Estate, Kitchenaide
Step-By-Step Instructions1
KitchenAid Electric Slide-In Range - KSEB900ESS2
2
Electric Range Inner Door Glass Replacement
3
Tools needed: Phillips-head screwdriver or a number two square driver
5
Be sure to unplug the power cord or shut off the power supply.
6
Fully open the oven door and rotate both door hinge locks back.
8
Partially close the door, then lift and pull the door toward you to remove.
9
With the handle side down, set the door on a sturdy surface.
10
Use a Phillips-head screwdriver or a number two square driver to unthread the three screws on the bottom of the door assembly and the two screws in the upper corners.
11
With the screws unthreaded, lift out the inner door panel.
12
Set the inner panel on a blanket with the hinges facing up.
13
You will now need to uninstall the two hinges.
14
Unthread the two bottom screws first.
15
Unthread the third screw on the outside of the door panel and you can fully remove the hinge.
16
Repeat for the opposite side.
18
Now lift the inner panel up and place a towel under the glass.
19
You can now unthread the remaining six screws securing the inner door glass brackets.
20
Set the inner door liner aside and remove the appropriate sheet of glass, if still intact.
21
Install the new inner door glass by aligning it in the frame.
22
Reposition the inner door liner, then realign each glass bracket and thread the screws loosely.
23
Once all of the brackets are in place tighten the screws.
24
Reinstall both door hinges.
25
Join the inner and outer door panels together.
26
Thread the five screws to secure.
27
Reinstall the oven door by inserting the door hinges into the hinge slots at a forty-five degree angle.
28
Lower the door to its fully open position, then rotate the hinge locks forward.
29
Plug the power cord back in or restore the power supply and the electric range should be ready for use.