DescriptionThis video provides step-by-step repair instructions for replacing the evaporator fan motor on a Whirlpool Sidekick freezer (Model WSZ57L18DM00). The most common reason for replacing this part is if the freezer is noisy or will not cool properly.
All of the information for this video is applicable to the following brands:
Whirlpool, Maytag, Amana, Kitchenaid, Kenmore
Step-By-Step Instructions1
Whirlpool Sidekick Freezer - WSZ57L18DM00
2
Freezer Evaporator Fan Motor Replacement
3
Tools needed: small flat-head screwdriver, Phillips-head screwdriver,
5
Be sure to unplug the power cord.
6
Remove all of the applicable shelving to reach the evaporator fan cover.
7
Use a Phillips-head screwdriver to unthread the three screws securing the cover.
8
Set the cover aside then unthread the two screws securing the motor mounting bracket.
9
Pull the front of the bracket down to detach.
10
Disconnect the motor wires along with the grounding wire.
11
Pull off the fan blade.
12
Use a small flat-head screwdriver to depress the tabs to release the rear motor support.
13
You can now pull out the old motor.
14
Before you install the new evaporator fan motor, make sure the support grommet is in place on the bracket.
15
Align the motor and snap the rear support in to hold it in place.
16
Slide the fan blade onto the motor shaft.
17
Connect the motor wires to the terminals along with the grounding wire
18
Reposition the mounting bracket and secure it with the screws.
19
Realign the cover?and rethread the screws.
20
Replace the shelving as necessary.
21
Plug the power cord back in and your freezer should be ready for use.