DescriptionThis video provides step-by-step repair instructions for replacing the LED control board on a KitchenAid 5 Door Refrigerator (Model KRMF706ESS01). The most common reason for replacing this part is if the LED's are not functioning properly.
All of the information for this video is applicable to the following brands:
Whirlpool, Maytag, Amana, Kitchenaid, Kenmore
Step-By-Step Instructions1
KitchenAid Five-Door Refrigerator - KRMF706ESS01
2
Refrigerator LED Control Board Replacement
3
heavy, sharp, shock, water
6
open the freezer drawer and pull the base grille forward to remove
7
use a quarter-inch socket or nut driver to rotate the brake feet counter-clockwise to raise them
9
you can now roll the appliance forward
10
use the quarter-inch socket or nut driver to unthread the screws to release the circuit board access panel
11
cut the retaining tape if necessary then use a small flat-head screwdriver to depress the tab to detach the plastic cover
12
disconnect the three wire connecter from the LED control board
13
lift the upper tab to release the old board
14
snap the new board into place on the housing
15
connect the wire connecter to the appropriate terminals on the new board
16
align and snap the plastic cover into place
17
replace the access panel and thread the screws to secure
19
push the refrigerator back against the wall
20
lower the front leveling legs until they are in contact with the floor
21
replace the base grille with the leveling assemblies then snap the grille into place
23
plug the power cord back in