DescriptionThis video provides step-by-step instructions for replacing the oven sensor on Frigidaire electric ranges.
All of the information in this video is applicable to the following brands: Frigidaire
Step-By-Step Instructions1
Frigidaire Electric Range - Model LFEF3054TFG
2
Electric Range Oven Sensor Replacement
3
Tools & Assistance Needed
4
"You will need a quarter-inch socket or nut driver for this procedure, and you may need assistance."
5
Be sure to unplug the power cord or shut off the power supply.
6
Have an assistant help you to move the range away from the wall.
7
Use a quarter-inch socket or nut driver to unthread the screws to release the upper rear access panel.
8
Unthread the bottom screw securing the lower access panel to the power cord retaining plate.
9
Unthread the four remaining mounting screws securing the panel.
10
Pull the panel up to remove.
11
Unthread the mounting screw securing the old oven sensor.
12
Slide the sensor out and disconnect the wire connecter.
13
Install the new oven sensor by first connecting the wire connecter.
14
Slide the sensor into place and thread the mounting screw.
15
"Reinstall the lower access panel by aligning the power cord retaining plate with the slots in the panel, then hook the bottom tabs on the frame, fully position the panel and thread the four side mounting screws."
16
Replace the bottom screw to secure the panel to the power cord retaining plate.
17
Realign the upper access panel by placing the panel tabs behind the lip of the control panel.
19
Move the appliance back against the wall.
20
Plug the power cord back in or restore the power supply.
21
Congrats! Your electric range is ready for use.