Price Match Guarantee
In-stock parts ship the same day
365-Day Return Policy
Price Match GuaranteeGET PRO PRICING
Video & Articles: Appliance & Equipment RepairFrigidaire Laundry Center Washer Drain Pump Replacement (5304524452)
Frigidaire Laundry Center Washer Drain Pump Replacement (5304524452)
Skill Level
Total Parts Cost
$141.32Estimated Savings
$112.5004:37
- Description
This video provides step-by-step repair instructions for replacing the washer drain pump on a Frigidaire electric washer/dryer laundry center (model FFLE3900UW1). The most common reason for replacing this part is if the washer will not drain properly.
This replacement video is applicable to the following brands:
Frigidaire
Don't forget to like and comment on this video and subscribe to our channel!
This replacement video is applicable to the following brands:
Frigidaire
Don't forget to like and comment on this video and subscribe to our channel!
Step By Step Instructions
1
To replace the drain pump in your frigidaire laundry center…
2
… you will need a 5/16th inch nut driver and both regular pliers and needle-nose pliers.
3
Before you begin the procedure, unplug the power cord…
4
… and shut off the incoming water supply.
5
Have an assistant help you to move the appliance away from the wall or out of the closet.
6
Detach the venting from the dryer.
7
Remove the hot and cold-water supply lines from the inlet valve – be prepared for some water to spill.
8
Remove the end of the drain hose from the standpipe or laundry tub.
9
Secure the washer lid with tape.
10
Now carefully tip the appliance back so it rests on its rear panel.
11
Use the pliers to release the retaining clamp securing the drain hose to the pump…
12
… then pull the hose off the pump.
13
Use the 5/16th inch nut driver or socket to unthread the three drain pump mounting screws.
14
Use the needle-nose pliers to detach the two wire retainers.
15
Disconnect the wire connecter to fully remove the old pump.
16
To prepare the new pump for installation…
17
… transfer the pump seal from the old pump to the new one.
18
Connect the wire connecter…
19
… and snap the wire retainers into place…
20
… then secure the wires under the retaining clip.
21
Position the pump on the tub…
22
… and thread the three mounting screws.
23
Attach the drain hose to the pump and secure it with the clamp.
24
Return the laundry center to its upright position.
25
Reinsert the drain hose into the standpipe or hook it onto the edge of the tub.
26
Reattach the hot and cold-water supply lines to the inlet valve ports.
27
Reattach the venting…
28
… and move the appliance back against the wall or into the closet.
29
Turn the water supply back on…
30
… plug the power cord back in…
31
… and your laundry center should be ready for use.
Description
This video provides step-by-step repair instructions for replacing the washer drain pump on a Frigidaire electric washer/dryer laundry center (model FFLE3900UW1). The most common reason for replacing this part is if the washer will not drain properly.
This replacement video is applicable to the following brands:
Frigidaire
Don't forget to like and comment on this video and subscribe to our channel!
This replacement video is applicable to the following brands:
Frigidaire
Don't forget to like and comment on this video and subscribe to our channel!
Step-By-Step Instructions
1
To replace the drain pump in your frigidaire laundry center…
2
… you will need a 5/16th inch nut driver and both regular pliers and needle-nose pliers.
3
Before you begin the procedure, unplug the power cord…
4
… and shut off the incoming water supply.
5
Have an assistant help you to move the appliance away from the wall or out of the closet.
6
Detach the venting from the dryer.
7
Remove the hot and cold-water supply lines from the inlet valve – be prepared for some water to spill.
8
Remove the end of the drain hose from the standpipe or laundry tub.
9
Secure the washer lid with tape.
10
Now carefully tip the appliance back so it rests on its rear panel.
11
Use the pliers to release the retaining clamp securing the drain hose to the pump…
12
… then pull the hose off the pump.
13
Use the 5/16th inch nut driver or socket to unthread the three drain pump mounting screws.
14
Use the needle-nose pliers to detach the two wire retainers.
15
Disconnect the wire connecter to fully remove the old pump.
16
To prepare the new pump for installation…
17
… transfer the pump seal from the old pump to the new one.
18
Connect the wire connecter…
19
… and snap the wire retainers into place…
20
… then secure the wires under the retaining clip.
21
Position the pump on the tub…
22
… and thread the three mounting screws.
23
Attach the drain hose to the pump and secure it with the clamp.
24
Return the laundry center to its upright position.
25
Reinsert the drain hose into the standpipe or hook it onto the edge of the tub.
26
Reattach the hot and cold-water supply lines to the inlet valve ports.
27
Reattach the venting…
28
… and move the appliance back against the wall or into the closet.
29
Turn the water supply back on…
30
… plug the power cord back in…
31
… and your laundry center should be ready for use.
Applicable Product Model
Parts Needed
Drain Pump
$141.32
Total$0.00
Related Articles & Videos
07:04
Part Replacement
Frigidaire Electric Laundry Center Dryer Drum Belt Replacement (134503600)
10:24
Part Replacement
Frigidaire Electric Laundry Center Heater Assembly Replacement (137392702)
09:35
Part Replacement
Frigidaire Electric Laundry Center Dryer Drum Bearing Replacement (131777700)
18:36
Part Replacement
Frigidaire Laundry Center Washer Transmission Assembly Replacement (5304517318)
04:37
Part Replacement
Frigidaire Laundry Center Water Inlet Valve Replacement (5304515818)
Our Story
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic
© 2026 RepairClinic.com