DescriptionThis video provides step-by-step repair instructions for replacing the fill hose on a Bosch dishwasher. The most common reason for replacing the fill hose is when it is leaking water.
All of the information for this fill hose replacement video is applicable to the following brands:
Bosch, Thermador, Gaggenau, Kenmore
Step-By-Step Instructions1
As with any repair, be sure to turn off the power to your dishwasher before beginning.
2
Your first step is to remove the screws to release the lower access panel.
3
Now open the dishwasher door and remove the screws securing the outer door panel.
4
Close the door securely and pull the outer door panel down to remove.
5
Uninstall the screws to release the inner access plate.
6
Detach the plate from the harness support and set it aside.
7
Move the sound dampening pad out of the way.
8
If still intact, release the old fill hose from the retaining clip and pull it off of the sump and air pressure chamber.
9
Be prepared for some water to spill out.
10
Install the new fill hose by inserting it into the port on the pressure chamber and the port on the sump.
11
Secure it in the retaining clip.
12
Reposition the sound dampening pad.
13
Replace the inner access plate by first attaching the harness support.
14
Then position and secure the screws.
15
Reinstall the outer door panel by sliding it up into position and replace the screws in the inner panel to secure.
16
Replace the lower access panel and secure the screws.
17
You’re now ready to turn the power supply back on and confirm that the dishwasher is functioning properly.