If your Electrolux dishwasher stops mid-cycle, the most likely problem is a bad or clogged water inlet valve. When the dishwasher drains and then tries to refill, a failed valve can keep water from entering, so the cycle stalls. Next, check the door latch, since a worn latch or door switch can tell the control board the door is open and shut the dishwasher down mid-cycle. It also helps to look for fault codes, because an Electrolux dishwasher that stops during cycle will often flash an error that points you in the right direction. If no code gives you a clear answer, the control board may not be sending power where it should. Less often, an Electrolux dishwasher shuts off mid-cycle because the circulation pump or pump and motor assembly is failing, especially if the unit fills but you hear only a humming sound or the wash arms are not moving. Check for debris in the pump housing and confirm power to the motor before replacing parts. Enter your model number on RepairClinic.com to find the exact water inlet valve, door latch, control board, circulation pump, or pump and motor assembly for your specific dishwasher.
01 - Electrolux Dishwasher Water Inlet Valve
The water inlet valve opens to allow water to enter the dishwasher. If the water valve fails, the dishwasher will stop in mid-cycle after the remaining water in the sump area has drained prior to the fill cycle. The water inlet valve coil can be tested for electrical continuity to help determine if the part is faulty. The valve could also be clogged. A clogged valve can not be cleaned and should be replaced.
Enter model number to search for the required part specific to your product
The dishwasher door needs to be properly latched for the appliance to work. If the latch is faulty, the door switch could signal the control board to stop the dishwasher in mid-cycle. Inspect the door latch for any damage and replace if necessary.
If the dishwasher stop mid-cycle, a fault code will usually be displayed to help diagnose the issue. Refer to the owner's manual or do an on-line search to find out more information regarding what the fault code means.
Common
04 - Electrolux Dishwasher Control Board
A dishwasher's control board provides power to nearly every electrical component in the dishwasher. A faulty board may be unable to supply power to all of the electrical components which can cause the dishwasher to stop mid-cycle.
The circulation pump uses a motor and impeller to force water up through the wash arms. If the circulation pump is defective, the dishes won’t be cleaned properly. If the motor isn’t making any noise or is just making a humming sound after the dishwasher has filled, the motor may be burned out. First, ensure that power is getting to the motor. Second, to ensure that the impeller can turn, check the pump housing for debris. If power is getting to the motor and the pump is clear of debris, the motor might need to be replaced. Be aware that the circulation pump may be challenging to replace, although many do-it-yourselfers ha...ve been successful with the replacement.
06 - Electrolux Dishwasher Pump and Motor Assembly
The motor drives an impeller to force water up through the wash arms. If the motor is defective, the pump impeller is broken, or some part of the pump is clogged, dishes won’t be cleaned properly. Make sure that power is getting to the circulation pump and motor. If power is getting to the pump and motor assembly but it still won’t run, replace the pump and motor assembly.