If your Thermador dishwasher spray arms are not spinning, the problem is usually tied to poor water delivery to the wash arm rather than the arm itself. On this Thermador dishwasher spray arm not turning issue, start with the most likely causes: a damaged or obstructed center wash arm support, lower wash arm support, or upper wash arm support. If any of these supports are cracked, clogged, or not lining up correctly with the water supply nozzle, water cannot reach the spray arm with enough force to spin it, which can leave you with a dishwasher not washing properly and dishes still dirty after the dishwasher cycle. Less commonly, the control board or main control board may fail to send power where it needs to go, affecting water fill through the water inlet valve and reducing wash performance. A bad timer is also possible, but it is often misdiagnosed and should be checked after the more common parts. Enter your model number on RepairClinic.com to find the exact Thermador replacement part that fits your dishwasher.
01 - Thermador Dishwasher Control Board
A dishwasher's control board provides power to nearly every electrical component in the dishwasher. A faulty board may be unable to supply power to the water inlet valve, preventing it from opening and allowing the necessary water to fill the tank.
Enter model number to search for the required part specific to your product
A dishwasher's main control board provides power to nearly every electrical component in the dishwasher. A faulty board may be unable to supply power to the water inlet valve, preventing it from opening and allowing the necessary water to fill the tank.
The timer allows power to flow to the proper parts at the proper times. If the timer isn’t working properly, it might not send voltage to the dishwasher, causing it not to start. Timers are often misdiagnosed—make sure you check more commonly defective parts before replacing the timer.
The center wash arm is attached to a support that is normally attached to the underside of the upper dishrack. Water flows through the support to the arm which circulates the water to the dishes in the upper rack. If the support is damaged or obstructed water may not flow properly. Inspect the support for any damage or obstruction and replace if necessary. In addition, make sure that the support is mating properly with the water supply nozzle.
The lower wash arm is attached to a support fastened to the sump assembly. Water flows through the support to the arm which circulates the water to the dishes in the lower dishrack. If the support is damaged or obstructed water may not flow properly. Inspect the support for any damage or obstruction and replace if necessary.
The upper wash arm is attached to a support that provides water to the arm to spray the dishes in the upper dishrack. If the support is damaged or obstructed water may not flow properly. Inspect the support for any damage or obstruction and replace if necessary.