If your Jenn Air dishwasher is overflowing, the most likely culprit is a water inlet valve that is stuck open and keeps letting water in after the tub is full. That is especially likely if you notice water dripping in with the door open or standing water collecting when the dishwasher is off. The next most likely cause is the main control board continuing to send power to the water inlet valve when it should shut off, followed by a cracked lower wash arm assembly that can throw water toward the door and mimic a dishwasher overfills with water problem. Too much detergent or the wrong detergent can also create excess suds and make a Jenn Air dishwasher overflowing issue look worse. A defective or stuck float switch is another possible cause if the dishwasher water level is too high and the safety float system is not cutting off the fill. Check each part carefully, and if replacement is needed, enter your model number on RepairClinic.com to find the exact Jenn Air water inlet valve, main control board, lower wash arm assembly, or float switch that fits your dishwasher.
01 - Jenn Air Dishwasher Water Inlet Valve
The water inlet valve is an electrically-controlled valve that opens to allow water to enter the dishwasher. Depending on the model, the valve stays open either for a set length of time or until the dishwasher has enough water. However, if the water inlet valve doesn’t shut off after the dishwasher has enough water, the dishwasher will overflow. If water drips into the dishwasher when the door is open, or if water collects at the bottom of the dishwasher while it is not use, you may need to replace the water inlet valve.
Enter model number to search for the required part specific to your product
A dishwasher's main control board provides power to nearly every electrical component in the dishwasher. If the control board continues to send power to the water inlet valve during the drain cycle, the dishwasher could overflow. While this is not that common of a problem, you can inspect the board for signs of burning or a shorted-out component. You can also use a multimeter to test the water inlet valve for incoming power during the dishwasher's cycle.
If the lower wash arm has a crack or split on the side it can cause water to splash out the bottom of the door, giving the impression that the dishwasher is overflowing. Inspect the wash arm assembly for any damage and replace if necessary.
Make sure to use the proper dishwasher detergent. Use the proper amount of detergent for your water hardness; too much soap in soft water can cause oversudsing and leaking.
Common
05 - Jenn Air Dishwasher Control Board
A dishwasher's control board provides power to nearly every electrical component in the dishwasher. If the control board continues to send power to the water inlet valve the dishwasher could overflow. While this is not that common of a problem, you can inspect the board for signs of burning or a shorted-out component. You can also use a multimeter to test the water inlet valve for incoming power during the dishwasher's cycle.
The float switch actuates in order to prevent the dishwasher from overflowing. If the float switch is defective or stuck, it might not stop the dishwasher from overflowing. If the float switch is defective, replace it.