Choose Product
Identify Problem
03
Find Solutions

Norge Dryer won't start

If your Norge dryer won't start, the most likely culprit is a blown thermal fuse caused by overheating from a restricted vent, so check and clean the exhaust and test the fuse for continuity with a multimeter first. If the fuse is good, confirm the door is fully closed and nothing is blocking it; a dryer will not start with the door ajar. Next check the start switch: if the dryer makes no noise or response the start switch may be defective, but if the motor hums and the dryer does not spin the start switch is probably okay. Listen for the door switch click and test it with a multimeter if you don’t hear one. A faulty control board can also prevent a dryer from turning on by not sending voltage to the motor. Finally, look for an object stuck in the blower wheel, which can cause the motor to hum and stop the drum from turning. If you need parts, enter your model number on RepairClinic.com to find the exact replacement part for your specific dryer.

01 - Norge Dryer Thermal Fuse

The thermal fuse is a safety device designed to protect the dryer from overheating. The fuse is located on the blower housing or at the dryer’s heat source such as the heating element on electric dryers or at the burner on gas models. The fuse should be closed for continuity meaning it has a continuous electrical path through it when good. If overheated the fuse will have no continuity meaning the electrical path is broken and the fuse has blown. A multimeter can be used to test it for continuity. Be aware that a blown thermal fuse is an indication of a restricted exhaust vent from the dryer to the outside. Always check t...he dryer venting when replacing a blown thermal fuse.
Enter model number to search for the required part specific to your product
Top Solution

02 - Door is not fully closed

Since the dryer will not start with the door open, confirm the door is fully closed and remove anything that is obstructing the door.
Top Solution

03 - Norge Dryer Start Switch

To determine if the start switch is defective, attempt to start the dryer. If the dryer hums but does not start, the start switch is not at fault. If the dryer does not respond or make any noise, the start switch could be at fault. Use a multimeter to test the start switch for continuity. If the switch does not have continuity, replace it.
Highly Likely

04 - Norge Dryer Door Switch

The door switch activates when the dryer door is closed. On most dryers, the door switch makes an audible clicking sound when it activates. To determine if the door switch is working, try starting your dryer and then listen for the “click.” If the door switch makes a clicking sound, it is probably not defective. If you don’t hear a click, use a multimeter to use the door switch for continuity. If the switch does not have continuity, replace it.
Common

05 - Norge Dryer Control Board

A dryer's control board controls the voltage being sent to all of the appliance's electrical components. If the board is defective, it may not allow the dryer to start. You can inspect the board for signs of damage or a shorted component. You can also use a multimeter to test for voltage reaching the drive motor after reviewing the dryer's wiring diagram.
Common

06 - Object stuck in blower wheel

If the dryer won’t start, an article of clothing may have gotten past the lint screen and is caught in the blower wheel. When this happens the drive motor will either hum but won’t start or will make a lot of noise when trying to start. The blower cover will need to be removed to check for obstructions. If the blower wheel is damaged it will need to be replaced.
Common

Frequently Asked Questions

My Norge dryer won't start. What should I check first?
Dryer hums but drum won't turn or dryer making grinding noise when drum turns. What's wrong?
How can I tell if the thermal fuse has blown and do I need to clean the vent?
Dryer not turning on at all — could it be the control board or start switch?
How do I enter my model number to find the correct replacement part on RepairClinic?