If your Frigidaire dryer drum has stopped spinning or your dryer is not spinning, the most common culprit is a broken drive belt. To check, open the door and turn the drum by hand; if it spins easily the belt is likely snapped. Inspect and replace the drive belt to restore rotation. A faulty timer can stop the drum too, but that is rare, so only test the timer with a multimeter after you eliminate more likely problems. Also confirm the power cord is fully seated, because a loose plug can cause the dryer not to spin or to stop mid-cycle. An obstructed or wobbly blower wheel can bind the drum and reduce vent airflow, so remove the vent and check for lint, stray socks, or a loose wheel. A worn idler pulley that has lost tension will let the belt slip and stop the drum, so replace the pulley and belt together when needed. Finally, if the dryer runs then stops or the motor feels hot, the drive motor may be overheating and failing; remove the belt and inspect the blower and drum for binding before swapping the motor. Enter your model number on RepairClinic.com to find the exact replacement part for your dryer.
01 - Frigidaire Dryer Drive Belt
The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. Over time, the belt can break from normal use. If the belt is broken, the dryer won’t turn. To quickly determine if the belt is broken, reach into the dryer and turn the drum by hand. If the drum spins very easily, the belt is likely broken. Next, inspect the belt to confirm that it is broken. If the belt is broken, replace it.
Enter model number to search for the required part specific to your product
A dryer drum that has stopped spinning unexpectedly could be caused by a faulty timer. However, this is very rarely the case. Before replacing the timer, check all the more commonly defective parts. If you determine that all of the other components are working properly, test the timer by using a multimeter and consulting the wiring diagram. If the timer is defective, replace it.
Confirm the power cord is plugged tightly into the wall receptacle. A loose plug can provide intermittent power to the dryer and cause it to stop spinning during the cycle.
Top Solution
04 - Frigidaire Dryer Blower Wheel
The blower wheel works with the drive motor to draw air into the dryer drum. Clumps of lint, socks, and small articles of clothing can escape the lint filter and get caught in the blower wheel. Since the blower wheel is usually attached to the same drive motor shaft that drives the drum belt, an obstructed blower wheel may prevent the drum from spinning. To determine if the blower wheel is working properly, remove the dryer vent and assess the strength of the air flow. If the air flow is weak, check the blower wheel for obstructions. If no obstructions are present, try rotating the blower wheel by hand. If the blower wheel... wobbles as it turns, replace it.
The dryer's idler pulley puts tension on the drive belt so the belt can rotate the drum during operation. A defective idler pulley can cause the dryer drum to stop spinning. Inspect the idler pulley and make sure it spins freely on the shaft. If the idler pulley is stuck, worn or damaged, we recommend replacing the drum drive belt in addition to replacing the idler pulley.
The drive motor turns the drum and the blower wheel to exhaust the air. If the dryer runs, stops for a while, and then starts again, this likely indicates that the motor is overheating, causing the dryer to shut off until the motor cools down. First, remove the belt from the motor and check the blower wheel to ensure that it is not obstructed. Next, with the belt removed, try rotating the drum by hand. If the drum does not rotate freely, determine what is causing the drum to bind. If the drum turns freely and the blower wheel is clear of obstructions, the drive motor might be defective. If you suspect the motor is at fault..., replace it.