Choose Product
Identify Problem
03
Find Solutions

Estate Dryer steam function not working

If your Estate dryer steam function is not working, start by treating the control board or main control board as the most likely cause—these boards often fail to send power to the water inlet or steam generator and are worth inspecting first for burned components or shorts. Next-most likely is a failed steam generator when power reaches the generator but no steam is produced. After that check the basic plumbing: make sure the water supply hose and Y-connector are attached and the home supply is on. Inspect the rear nozzle for clogs or damage that would block mist entering the drum, and finally test the water inlet valve with a multimeter for continuity if no mist appears when energized. For confident DIYers and first-timers alike, a visual board inspection, confirming the water hookup, clearing debris from the nozzle, and a simple continuity check on the valve will narrow the problem quickly. Enter your model number on RepairClinic.com to find the exact replacement control board, steam generator, nozzle, or inlet valve for your dryer.

01 - Estate Dryer Control Board

If no power is getting to either the dryer's water inlet valve during the steam cycle or the steam generator, then it's likely the dryer's control board is defective and the cause of the steam function problem. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.
Enter model number to search for the required part specific to your product
Common

02 - Estate Dryer Main Control Board

If no power is getting to either the dryer's water inlet valve during the steam cycle or the steam generator, then it's likely the dryer's main control board is defective and the cause of the steam function problem. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.
Common

03 - Estate Dryer Steam Generator

If no power is getting to the dryer's water inlet valve during the steam cycle, but power is reaching the steam generator, then it's likely the steam generator is defective and will need to be replaced.
Common

04 - Water supply not connected.

The water supply hose needs to be connected from the home's water supply to the water inlet valve on the dryer. The water line is usually connected to a “Y” connector and shares the same cold-water supply as the washer. Refer to the owner's manual for water hookup instructions.
Common

05 - Estate Dryer Nozzle

The nozzle, normally located at the rear interior of the dryer, may be damaged or clogged with debris and unable to allow the steam to enter the drum area. Inspect the nozzle or any damage or obstruction and replace if necessary.
Less Common

06 - Estate Dryer Water Inlet Valve

The dryer's water inlet valve provides the water necessary for the steam function to work. If there is no mist coming from the nozzle when the valve is energized, it's likely the inlet valve is defective. You can use a multimeter to test the valve for electrical continuity. If the valve tests negative for continuity, you'll know the part has failed and will need to be replaced.
Less Common

Frequently Asked Questions

Why is my dryer steam not working?
How do I test the dryer water inlet valve?
No mist from the nozzle during the steam cycle — is the steam generator bad?
Can a bad control board cause the steam cycle to fail?
How do I enter my model number or part number on RepairClinic.com to get the correct replacement part?