Choose Product
Identify Problem
03
Find Solutions

Speed Queen Commercial Dryer steam function not working

If your Speed Queen commercial dryer steam function not working, the most likely cause is an electrical control failure — either the control board or the main control board — which can stop power from reaching the water inlet or steam generator; inspect the board for burned components or shorts. If the board is fine but the steam cycle still fails, the steam generator itself is the next probable culprit, followed by a simple water hookup issue where the supply hose is not connected. Less common causes include a clogged or damaged nozzle that prevents steam from entering the drum and a failed water inlet valve that will test open on a multimeter if it has lost continuity. Whether you’re troubleshooting the steam fresh or steam sanitize function, start with power and wiring checks, then verify the water feed and nozzle, and replace the defective part as needed. Enter your model number on RepairClinic.com to find the exact replacement part for your specific dryer and get step-by-step repair guidance.

01 - Speed Queen Commercial Dryer Control Board

If no power is getting to either the dryer's water inlet valve during the steam cycle or the steam generator, then it's likely the dryer's control board is defective and the cause of the steam function problem. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.
Enter model number to search for the required part specific to your product
Common

02 - Speed Queen Commercial Dryer Main Control Board

If no power is getting to either the dryer's water inlet valve during the steam cycle or the steam generator, then it's likely the dryer's main control board is defective and the cause of the steam function problem. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.
Common

03 - Speed Queen Commercial Dryer Steam Generator

If no power is getting to the dryer's water inlet valve during the steam cycle, but power is reaching the steam generator, then it's likely the steam generator is defective and will need to be replaced.
Common

04 - Water supply not connected.

The water supply hose needs to be connected from the home's water supply to the water inlet valve on the dryer. The water line is usually connected to a “Y” connector and shares the same cold-water supply as the washer. Refer to the owner's manual for water hookup instructions.
Common

05 - Speed Queen Commercial Dryer Nozzle

The nozzle, normally located at the rear interior of the dryer, may be damaged or clogged with debris and unable to allow the steam to enter the drum area. Inspect the nozzle or any damage or obstruction and replace if necessary.
Less Common

06 - Speed Queen Commercial Dryer Water Inlet Valve

The dryer's water inlet valve provides the water necessary for the steam function to work. If there is no mist coming from the nozzle when the valve is energized, it's likely the inlet valve is defective. You can use a multimeter to test the valve for electrical continuity. If the valve tests negative for continuity, you'll know the part has failed and will need to be replaced.
Less Common

Frequently Asked Questions

Dryer steam not working — what should I check first?
Dryer controls not working and steam won't run — is the control board bad?
Dryer steam not working — why is there no mist from the nozzle?
Dryer leaking water when using steam — what could be causing it?
How do I enter my model number or part number to find the right replacement part on RepairClinic.com?