If your dryer keeps tripping the circuit breaker, start with the most likely causes and work down the list: a weak or aging breaker, a heating element or heating element assembly that has shorted to the heater housing, damaged or loose power cord terminals at the terminal block, or an internal short in the drive motor. A shorted heating element will show continuity to the case when checked with a multimeter, and burnt or melted prongs and wires at the cord or terminal block are an obvious sign of a cord-related short. Always shut power off before inspecting or testing anything. If you find a shorted heating element, a burnt power cord, or a motor with shorted windings, replacing that part will usually stop the dryer from tripping the breaker. If you have checked the dryer components and the problem persists, the breaker itself may be weak and should be evaluated by an electrician. Enter your model number on RepairClinic.com to find the exact replacement part for your dryer.
01 - The Circuit Breaker is Weak
Over time, circuit breakers can weaken. If the circuit breaker is weak, it may trip, even if the amperage draw from the dryer is below the breakers limit. If you have already checked all of the potentially defective dryer components, consider having an electrician replace the circuit breaker.
Top Solution
02 - Haier Dryer Heating Element
Sometimes, if the heating element fails, it shorts out against the heater housing, causing the dryer to trip the circuit breaker. To determine if the heating element is at fault, use a multimeter to test each terminal for continuity to the case. If the heating element has continuity to the case, it is shorted out. If the heating element is shorted out, replace it.
Enter model number to search for the required part specific to your product
Sometimes, if the heating element fails, it shorts out against the heater housing, causing the dryer to trip the circuit breaker. To determine if the heating element assembly is shorted out, use a multimeter to test each terminal for continuity to the case. If the heating element assembly has continuity to the case, it is shorted out. If the heating element assembly is shorted out, replace it.
If the dryer's power cord wire terminal connections are not secured properly to the terminal block, the terminal block can short out and cause a circuit breaker to trip or a fuse to blow. You should inspect both the terminal block and the power cord terminal connections for damage. If the power cord wire terminals are burnt or melted, you will need to replace the power cord.
Loose or burnt power cord connections can cause restricted current flow, making the circuit breaker overheat and trip. Shut off power to the dryer, then check the power cord connections and receptacle for burnt prongs, wires, or terminals. If the power cord or terminal block is damaged it will need to be replaced.
Common
06 - Haier Dryer Drive Motor
Sometimes, when the drive motor fails, it shorts out internally, causing the dryer to trip the circuit breaker. To determine if the drive motor is at fault, use a multimeter to test it for continuity. If the motor windings are shorted out, replace the drive motor.