Choose Product
Identify Problem
03
Find Solutions

Jenn Air Oven not self-cleaning

When your Jenn Air oven self-clean is not working, the touchpad is the most likely cause, especially if pressing the self-clean button does not turn on the door lock indicator or produce the low hum of the lock motor. A faulty touchpad may need replacement. Next, check the door lock motor and switch assembly. This assembly activates during the self-cleaning cycle and can prevent the door from unlocking when the cycle ends. A defective temperature control thermostat can also stop self-cleaning even if the oven bakes and broils normally, because it regulates voltage and temperature during cleaning. A damaged door latch or failed latch microswitch may prevent the cycle from starting because the door cannot lock securely. If those parts test good, a failed oven control board may not send voltage to the bake and broil circuits. Always follow the owner's manual before working around the door lock mechanism. To find the correct Jenn Air replacement part for your range, stove, or oven, enter your model number and match the part to your appliance.

01 - Jenn Air Range/Stove/Oven Touchpad

The door lock indicator light should come on and you should hear the lock motor running when the self-clean button is pressed. If the indicator light does not come on and you don't hear a low humming noise as the door is being locked, it's likely the oven's touchpad is faulty and will need to be replaced.
Enter model number to search for the required part specific to your product
Top Solution

02 - Jenn Air Range/Stove/Oven Door Lock Motor and Switch Assembly

During the oven's self-cleaning cycle, the door lock switch activates the door lock motor to prevent the oven door from being opened. If the door lock motor and switch assembly is defective, the oven door will not unlock once the self-cleaning cycle is complete. On most ovens, you can open the oven door by removing certain screws or panels. Check your owner's manual for further instructions.
Top Solution

03 - Jenn Air Range/Stove/Oven Temperature Control Thermostat

The oven thermostat sends voltage to the heating circuit and regulates the temperature of the oven during the self-cleaning cycle. It is possible for the oven thermostat to function properly for baking and broiling but not for cleaning. Due to its complexity, the oven thermostat is difficult to test. If you suspect the oven thermostat is at fault, replace it.
Highly Likely

04 - Jenn Air Range/Stove/Oven Door Latch

For your safety, the self-clean cycle will not begin unless the oven door is locked. If the door latch is broken and unable to allow the door to be locked, the self-clean cycle will not begin. Inspect the latch for damage. You can also use a multimeter to test the latch assembly's microswitch, if applicable, to determine if the switch has appropriate electrical continuity. If the latch is damaged or the microswitch tests negative for continuity, the door latch should be replaced.
Highly Likely

05 - Jenn Air Range/Stove/Oven Oven Control Board

The oven control board has relays that send voltage to the bake and broil circuits according to the user settings and sensor input. If the control board is defective, it may not send voltage to the heating components.
Highly Likely

06 - Jenn Air Range/Stove/Oven Control Board

The control board has relays that send voltage to the bake and broil circuits according to the user settings and sensor input. If the control board is defective, it may not send voltage to the heating components.
Common

Frequently Asked Questions

Why is my Jenn Air oven self-clean not working?
Why won't my Jenn Air oven door lock during self-clean?
Why is my Jenn Air oven door locked after the self-clean cycle?
Can a Jenn Air oven thermostat cause self-clean problems?
How do I find the correct Jenn Air self-clean oven part?