If your Kelvinator oven self clean is not working, start with the touchpad. When you press the self-clean button, the door lock indicator should light and you should hear a low hum from the lock motor. If neither happens, the touchpad is the most likely cause. Next, check the door lock motor and switch assembly. A defective assembly may prevent the cycle from starting or keep the door locked after cleaning is complete. The temperature control thermostat is another possibility because it regulates the heating circuit during self-cleaning, even if the oven still bakes and broils normally. A damaged door latch or failed latch microswitch can also stop the cycle because the door must lock before self-cleaning begins. If those parts check out, the oven control board may not be sending voltage to the bake and broil circuits. This self cleaning oven troubleshooting guide can help you identify the failed component before ordering parts. Enter your Kelvinator oven model number to find the exact replacement touchpad, door lock motor and switch assembly, thermostat, latch, or control board for your appliance.
01 - Kelvinator Range/Stove/Oven Touchpad
The door lock indicator light should come on and you should hear the lock motor running when the self-clean button is pressed. If the indicator light does not come on and you don't hear a low humming noise as the door is being locked, it's likely the oven's touchpad is faulty and will need to be replaced.
Enter model number to search for the required part specific to your product
02 - Kelvinator Range/Stove/Oven Door Lock Motor and Switch Assembly
During the oven's self-cleaning cycle, the door lock switch activates the door lock motor to prevent the oven door from being opened. If the door lock motor and switch assembly is defective, the oven door will not unlock once the self-cleaning cycle is complete. On most ovens, you can open the oven door by removing certain screws or panels. Check your owner's manual for further instructions.
03 - Kelvinator Range/Stove/Oven Temperature Control Thermostat
The oven thermostat sends voltage to the heating circuit and regulates the temperature of the oven during the self-cleaning cycle. It is possible for the oven thermostat to function properly for baking and broiling but not for cleaning. Due to its complexity, the oven thermostat is difficult to test. If you suspect the oven thermostat is at fault, replace it.
For your safety, the self-clean cycle will not begin unless the oven door is locked. If the door latch is broken and unable to allow the door to be locked, the self-clean cycle will not begin. Inspect the latch for damage. You can also use a multimeter to test the latch assembly's microswitch, if applicable, to determine if the switch has appropriate electrical continuity. If the latch is damaged or the microswitch tests negative for continuity, the door latch should be replaced.
05 - Kelvinator Range/Stove/Oven Oven Control Board
The oven control board has relays that send voltage to the bake and broil circuits according to the user settings and sensor input. If the control board is defective, it may not send voltage to the heating components.
The control board has relays that send voltage to the bake and broil circuits according to the user settings and sensor input. If the control board is defective, it may not send voltage to the heating components.