Choose Product
Identify Problem
03
Find Solutions

Tappan Oven not self-cleaning

If your Tappan oven self-clean is not working, the touchpad is the most likely cause, especially if pressing the self-clean button does not turn on the door lock indicator or produce the low hum of the lock motor. A faulty touchpad may need replacement. Next, check the door lock motor and switch assembly. This assembly locks the oven door during the self-cleaning cycle, and a failure can leave the door locked after cleaning or prevent the cycle from operating correctly. A defective temperature control thermostat can also stop self-cleaning, even when the oven bakes and broils normally. The door latch is another common cause because the self-clean cycle will not start unless the latch locks the door. Inspect it for damage and test its microswitch for continuity if equipped. Finally, a faulty oven control board may fail to send voltage to the heating circuit. Disconnect power before testing or replacing parts. Enter your Tappan oven's model number to find the exact replacement touchpad, door lock assembly, thermostat, latch, or control board for your appliance.

01 - Tappan Range/Stove/Oven Touchpad

The door lock indicator light should come on and you should hear the lock motor running when the self-clean button is pressed. If the indicator light does not come on and you don't hear a low humming noise as the door is being locked, it's likely the oven's touchpad is faulty and will need to be replaced.
Enter model number to search for the required part specific to your product
Top Solution

02 - Tappan Range/Stove/Oven Door Lock Motor and Switch Assembly

During the oven's self-cleaning cycle, the door lock switch activates the door lock motor to prevent the oven door from being opened. If the door lock motor and switch assembly is defective, the oven door will not unlock once the self-cleaning cycle is complete. On most ovens, you can open the oven door by removing certain screws or panels. Check your owner's manual for further instructions.
Top Solution

03 - Tappan Range/Stove/Oven Temperature Control Thermostat

The oven thermostat sends voltage to the heating circuit and regulates the temperature of the oven during the self-cleaning cycle. It is possible for the oven thermostat to function properly for baking and broiling but not for cleaning. Due to its complexity, the oven thermostat is difficult to test. If you suspect the oven thermostat is at fault, replace it.
Highly Likely

04 - Tappan Range/Stove/Oven Door Latch

For your safety, the self-clean cycle will not begin unless the oven door is locked. If the door latch is broken and unable to allow the door to be locked, the self-clean cycle will not begin. Inspect the latch for damage. You can also use a multimeter to test the latch assembly's microswitch, if applicable, to determine if the switch has appropriate electrical continuity. If the latch is damaged or the microswitch tests negative for continuity, the door latch should be replaced.
Highly Likely

05 - Tappan Range/Stove/Oven Oven Control Board

The oven control board has relays that send voltage to the bake and broil circuits according to the user settings and sensor input. If the control board is defective, it may not send voltage to the heating components.
Highly Likely

06 - Tappan Range/Stove/Oven Control Board

The control board has relays that send voltage to the bake and broil circuits according to the user settings and sensor input. If the control board is defective, it may not send voltage to the heating components.
Common

Frequently Asked Questions

Why is my Tappan oven self-clean not working?
Why won't my Tappan oven door lock during self-clean?
Why is my Tappan oven door locked after the self-clean cycle?
Could the Tappan oven thermostat or control board stop self-clean from working?
How do I find the correct Tappan self-clean replacement part?