If your Tappan wall oven has a burning smell, unplug it or switch off its circuit breaker before inspecting it, especially if you notice smoke or an electrical burning smell from the oven. The most likely cause is a defective temperature control thermostat, which can affect broiler operation and may need to be replaced. Next, check the oven control board and main control board. Their relays send voltage to the heating components, and a failed relay can overheat or stop controlling the oven correctly. A damaged bake element or broil element can also cause an oven burning smell. Look for holes, blisters, or areas that do not glow red during operation, then test the element for continuity with a multimeter. Finally, inspect the terminal block and power connections for loose, scorched, or melted wires. Do not operate the Tappan wall oven until damaged wiring is repaired. Enter your model number to find the exact replacement thermostat, control board, bake element, broil element, or terminal block for your specific wall oven.
01 - Tappan Range/Stove/Oven Temperature Control Thermostat
The temperature control thermostat regulates the broiler temperature. If the thermostat is defective, it may fail to heat the broiler element. The oven thermostat is not repairable—if the thermostat is defective, you must replace it.
Enter model number to search for the required part specific to your product
The control board has relays that send voltage to the surface element circuits according to the user settings and sensor input. If the control board is defective, it may not send voltage to the heating components.
The control board has relays that send voltage to the surface element circuits according to the user settings and sensor input. If the control board is defective, it may not send voltage to the heating components.
When the bake element is heating properly, it glows red hot. If the element does not glow red, this indicates that the element is not heating. Often, if the heating element has burned out, it will be visibly damaged. Inspect the heating element for holes or blisters. To determine if the bake element has burned out, use a multimeter to test the element for continuity. If the bake element does not have continuity, replace it.
The broil element may have burned out. When the broil element is heating properly, it glows red hot. If the element does not glow red, this indicates that the element is not heating. Often, if the element has burned out, it will be visibly damaged. Inspect the broil element for holes or blisters. To determine if the broil element has burned out, use a multimeter to test the element for continuity. If the broil element does not have continuity, replace it.
If the power cord connections in the terminal block on your electric range are not secure the wire can overheat, burning the connections on the terminal block, and melting the coating on the wires. Check to ensure the connections are tight and not burnt. If the terminal block connectors are burnt, the terminal block should be replaced. If the power cord terminal connectors are burnt or damaged, the power cord should be replaced. If the power cord prongs are burnt, a new power cord should be installed and the receptacle checked and replaced if necessary by a licenced electrician.