When your Inglis range is making a loud noise, start by checking the fan blade, the most likely cause. A bent blade or blade slipping on the shaft can rub against the housing and create an oven fan noise or rattling sound. If you hear a sudden whoosh from a gas burner, the spark ignition switch or spark ignition switch and harness may be working intermittently, allowing gas to build up before ignition. Test the switch for electrical continuity with a multimeter. A worn fan motor is another common cause, especially when its bearings are failing or the blade or blower is damaged. For an oven making noise during ignition, inspect the igniter. A weak igniter may glow for more than 90 seconds without lighting the gas, causing a small boom or whoosh. Finally, a failing convection motor can rattle, wobble, or allow the convection fan to hit the housing. Disconnect power and shut off the gas before inspecting or testing parts. Enter your Inglis range model number to find the exact replacement fan blade, motor, igniter, spark switch, or harness for your appliance.
01 - Inglis Range/Stove/Oven Fan Blade
The fan blade may be bent or sliding on the shaft and rubbing on the housing. Inspect the fan blade. If the fan blade is bent or damaged it will need to be replaced.
Enter model number to search for the required part specific to your product
If the gas is not lighting correctly, it can build up and flash, causing a “whoosh” noise on the burner. This can potentially be caused by a faulty spark ignition switch only working intermittently. You can use a multimeter to test the spark ignition switch or switches for electrical continuity to determine if the component is functioning normally.
03 - Inglis Range/Stove/Oven Spark Ignition Switch and Harness
If the gas is not lighting correctly, it can build up and flash, causing a “whoosh” noise on the burner. This can potentially be caused by a faulty spark ignition switch and harness only working intermittently. You can use a multimeter to test the spark ignition switches for electrical continuity to determine if the assembly is functioning normally.
The fan motor turns the fan blade to circulate the air. The fan motor is often sold as an assembly. If the fan motor bearings are bad, or the fan blade or blower is damaged, the fan motor will need to be replaced.
If the gas is not being ignited promptly, it can build up and flash causing a small "boom" noise in the oven or a "whoosh" noise on the burner. A faulty igniter could be the cause of the gas not igniting promptly. To determine if the igniter is defective, observe the igniter when the oven is on. If the igniter glows for more than 90 seconds without igniting the gas flame, this indicates that the igniter is too weak to open the valve. If the igniter is weak, replace it. If the igniter does not glow at all, use a multimeter to test the igniter for continuity. If the igniter does not have continuity, replace it.
The convection motor drives the convection fan to circulate the air inside the oven. The convection oven must circulate the air for the oven to heat evenly. If the motor bearings are bad the motor may rattle or the fan may hit the housing. If the convection fan motor shaft wobbles, or the motor is making a loud noise, replace the convection motor.