If your refrigerator dispenser is leaking water, start with the most likely causes so you can fix it without guessing. A broken or misaligned dispenser door is the top suspect because it may not seal or open correctly; remove the dispenser control panel or frame to inspect the door, hinges and chute for cracks, broken tabs or jammed linkage. Next check house water pressure by running the kitchen faucet since the inlet valve needs at least 20 psi to operate without leaking. Inspect the dispenser actuator and related linkage, because a damaged actuator can fail to engage switches properly. If pressure and actuator look fine, test the refrigerator water inlet valve for blockages, failed solenoids or loss of continuity with a multimeter and replace it if necessary. Finally test each dispenser switch for continuity, since a stuck or shorted switch can let the valve run uncontrolled and cause a constant drip. If your fridge is leaking water on the floor or the dispenser is dripping, enter your model number at RepairClinic.com to find the exact replacement part for your refrigerator and step by step repair help.
01 - Admiral Refrigerator Dispenser Door
The dispenser door is opened by a motor or a solenoid to dispense the ice, but if the door is broken, it may not open properly in order to release the ice. You should inspect the dispenser door for damage to determine if the component should be replaced. You may have to remove the dispenser control panel or frame to access and inspect the dispenser door.
Enter model number to search for the required part specific to your product
The water inlet valve, which supplies water to the refrigerator water dispenser, requires sufficient water pressure to work properly. If the water pressure is too low, the dispenser will leak. You can check the water flow at the kitchen faucet to help determine if the home's water pressure is sufficient or not.
Common
03 - Admiral Refrigerator Dispenser Actuator
The dispenser actuator is the component that activates the switch or switches to send voltage to the dispenser. If the dispenser actuator is damaged, it may be unable to activate the switch. Inspect the dispenser actuator for any damage and replace with a new one if necessary.
A refrigerator water inlet valve will direct water to the dispenser as well as the ice maker fill tube. If the inlet valve is obstructed, the solenoid coils on the valve are defective, or the home's water pressure is too low, the water valve will not work properly. The valve requires at least 20psi to function properly. Make sure that the water pressure to the valve is at least 20 psi. If the water pressure is sufficient, use a multimeter to test the water inlet valve for continuity. If the water inlet valve does not have continuity, replace it.
The dispenser switches send voltage to the dispenser. If one of the dispenser switches is defective, the dispenser will not work. To determine if a dispenser switch is defective, use a multimeter to test each switch for continuity. If a dispenser switch does not have continuity, replace it.