If your Danby refrigerator dispenser is leaking water into the drip tray or onto the floor, start by inspecting the dispenser door for cracks, broken hinges or misalignment since a damaged door often fails to close and is the most likely cause. If the door looks fine, check the home water pressure at a nearby faucet; low water pressure can make the inlet valve bleed or drip. Next, inspect the dispenser actuator and the dispenser switches that send voltage to the dispenser—worn actuators or bad switches can leave the valve energized or the door open. Less commonly the water inlet valve itself is obstructed or its solenoids are failing; the valve needs about 20 psi to seal properly and should be tested for continuity with a multimeter. You can find replacement dispenser doors, actuators, inlet valves and switches on RepairClinic.com, and enter your model number to see the exact part that fits your Danby refrigerator.
01 - Danby Refrigerator Dispenser Door
The dispenser door is opened by a motor or a solenoid to dispense the ice, but if the door is broken, it may not open properly in order to release the ice. You should inspect the dispenser door for damage to determine if the component should be replaced. You may have to remove the dispenser control panel or frame to access and inspect the dispenser door.
Enter model number to search for the required part specific to your product
The water inlet valve, which supplies water to the refrigerator water dispenser, requires sufficient water pressure to work properly. If the water pressure is too low, the dispenser will leak. You can check the water flow at the kitchen faucet to help determine if the home's water pressure is sufficient or not.
Common
03 - Danby Refrigerator Dispenser Actuator
The dispenser actuator is the component that activates the switch or switches to send voltage to the dispenser. If the dispenser actuator is damaged, it may be unable to activate the switch. Inspect the dispenser actuator for any damage and replace with a new one if necessary.
A refrigerator water inlet valve will direct water to the dispenser as well as the ice maker fill tube. If the inlet valve is obstructed, the solenoid coils on the valve are defective, or the home's water pressure is too low, the water valve will not work properly. The valve requires at least 20psi to function properly. Make sure that the water pressure to the valve is at least 20 psi. If the water pressure is sufficient, use a multimeter to test the water inlet valve for continuity. If the water inlet valve does not have continuity, replace it.
The dispenser switches send voltage to the dispenser. If one of the dispenser switches is defective, the dispenser will not work. To determine if a dispenser switch is defective, use a multimeter to test each switch for continuity. If a dispenser switch does not have continuity, replace it.