Choose Product
Identify Problem
03
Find Solutions

Tappan Refrigerator beeping/alarm sounding

If your refrigerator is beeping or the refrigerator alarm is sounding, start by reading the display for a fault code — that code will usually point you to the cause. The most likely fix is a simple power-reset after an outage, so flip the breaker off for a few minutes and back on to clear a power-failure alert. If the fridge is still beeping, a faulty door switch is a common culprit, especially when the fridge beeps with the door closed; you can test the switch for continuity with a multimeter and replace it if it fails. If the switch and cooling are fine, the dispenser control board can trigger alarms, followed by problems with the user control and display board or the main control board if buttons or the display act up. Before ordering parts, confirm the symptom and any fault codes, then enter your model number on RepairClinic.com to find the exact replacement part for your refrigerator and get step-by-step repair guidance.

01 - Check Fault Codes

When a refrigerator is beeping, a fault code will usually be displayed to help diagnose the issue. Refer to the owner's manual or do an on-line search for fault code designations and possible solutions.
Top Solution

02 - Power outage reset

After a power outage the refrigerator display will typically beep and/or flash a code like PO for power outage or PF for power failure. Try turning the breaker off for a few minutes then back on to reset the refrigerator or refer to the owner's manual for specific resetting information.
Highly Likely

03 - Tappan Refrigerator Door Switch

A refrigerator door switch is used to turn on the interior lights when a door is opened and to ensure the door with a water and ice dispenser is closed before dispensing ice. If the switch is defective, it may signal to the control that a door is open even when it is fully closed resulting in a beeping alarm sound. You can use a multimeter to test the door switch for appropriate electrical continuity. If the switch does not test appropriately, it should be replaced.
Enter model number to search for the required part specific to your product
Common

04 - Tappan Refrigerator Dispenser Control Board

If the refrigerator is cooling properly and the door switch is functioning normally, a faulty dispenser control board could be the cause of the beeping noise. Replace the old control board with a new one to see if that resolves the problem.
Less Common

05 - Tappan Refrigerator User Control and Display Board

To determine if the user control and display board is defective, try pressing the buttons on the control panel. If some of the buttons work, but others do not work, the user control and display board might need to be replaced. Additionally, if the display is not working, check the power to the user control and display board. If the user control and display board has power, but it isn’t working, replace it.
Less Common

06 - Tappan Refrigerator Control Board

If the refrigerator is cooling properly and the door switch is functioning normally, a faulty control board could be the cause of the beeping noise. Replace the old control board with a new one to see if that resolves the problem.
Less Common

Frequently Asked Questions

My refrigerator is beeping with the door closed. What should I check first?
The fridge display shows PO or PF and it's beeping. How do I reset it?
How do I test the refrigerator door switch with a multimeter?
Can a faulty control panel or dispenser control board make the fridge beep even if it is cooling properly?
How do I find the correct replacement part on RepairClinic.com using my model or part number?

Shop by Tappan Refrigerator Parts