Choose Product
Identify Problem
03
Find Solutions

Bosch Refrigerator water dispenser not working

If your Bosch fridge water dispenser not working or the refrigerator dispenser not dispensing water, start with the dispenser actuator — it is the small plastic lever that trips the switch; if it is cracked or worn the switch never gets voltage. Next suspect a frozen water tube inside the door: disconnect the tube at the bottom of the door and blow air through it, and make sure the freezer is set between 0 and 10 degrees Fahrenheit so the line does not freeze. If the tube is clear, test the water inlet valve and the home's water pressure. The inlet valve needs about 20 psi to open and should show continuity on a multimeter; replace it if it fails the test. Check the house supply by running the kitchen faucet, reseat or replace a misaligned water filter, and confirm the refrigerator water supply valve under the sink is fully open. Enter your model number on RepairClinic.com to find the exact replacement part for your refrigerator and get the correct actuator, valve, tube, or filter.

01 - Bosch Refrigerator Dispenser Actuator

The dispenser actuator is the component that activates the switch or switches to send voltage to the dispenser. If the dispenser actuator is damaged, it may be unable to activate the switch. Inspect the dispenser actuator for any damage and replace with a new one if necessary.
Enter model number to search for the required part specific to your product
Top Solution

02 - Water Tube in Door is Frozen

To determine if the water supply tube is frozen, disconnect the tube at the bottom of the door and blow air through it. If air does not pass through, this indicates that the water supply tube is frozen. If the water supply tube is frozen, thaw it out. In addition, ensure that the freezer is kept at the proper temperature. The freezer temperature should be kept from 0 to10 degrees Fahrenheit (-18 to -12 degrees Celsius). If the freezer is too cold, the water line may freeze.
Top Solution

03 - Bosch Refrigerator Water Inlet Valve

The water inlet valve opens to supply water to the dispenser. If the water inlet valve is defective, or if the water pressure is too low, the water valve will not open. The valve requires at least 20psi to function properly. Make sure that the water pressure to the valve is at least 20 psi. If the water pressure is sufficient, use a multimeter to test the water inlet valve for continuity. If the water inlet valve does not have continuity, replace it.
Top Solution

04 - Low Water Pressure from House Supply

The home may have insufficient water pressure. The water inlet valve requires strong water pressure to supply water to the water dispenser. You can check the water flow at the kitchen faucet to help determine if the home's water pressure is sufficient or not.
Highly Likely

05 - Misaligned water filter

Water filter may not be seated properly. Remove and reinstall the water filter. For optimal performance, refrigerator water filters should be replaced every six months or after 200-300 gallons (760-1150 liters) of water have been dispensed - whichever comes first. Replace the water filter if needed.
Highly Likely

06 - Home's water supply valve not fully open

The refrigerator is connected to a water supply valve that may not be fully open. If the water line was disconnected or the valve was shut off for service, it may not have been turned back on to the fully opened position.
Highly Likely

Frequently Asked Questions

My refrigerator water dispenser not working, what should I check first?
How can I tell if the water tube in the door is frozen?
How do I test the refrigerator water inlet valve?
Could a misaligned or clogged water filter stop my dispenser from working?
How do I find and buy the correct replacement part on RepairClinic.com?

Shop by Bosch Refrigerator Parts