Choose Product
Identify Problem
03
Find Solutions

Hardwick Refrigerator water dispenser not working

If your refrigerator water dispenser is not working, start with the most likely fixes so you can get cold water flowing again. The top cause is a worn or broken dispenser actuator that fails to activate the switch; next check for a frozen water tube in the door by disconnecting and blowing air through the line; then inspect the water inlet valve or test it with a multimeter, since a defective valve or insufficient water pressure will stop flow; low house water pressure can mimic a bad valve so check the kitchen faucet flow; a misaligned or clogged water filter is another common offender so remove and reseat or replace the filter; and finally confirm the home shutoff valve feeding the fridge is fully open. These same checks apply whether you search for refrigerator water dispenser not working or fridge water dispenser not working. If you need parts, enter your model number on RepairClinic.com to find the exact replacement dispenser actuator, inlet valve, filter, or other parts that fit your refrigerator.

01 - Hardwick Refrigerator Dispenser Actuator

The dispenser actuator is the component that activates the switch or switches to send voltage to the dispenser. If the dispenser actuator is damaged, it may be unable to activate the switch. Inspect the dispenser actuator for any damage and replace with a new one if necessary.
Enter model number to search for the required part specific to your product
Top Solution

02 - Water Tube in Door is Frozen

To determine if the water supply tube is frozen, disconnect the tube at the bottom of the door and blow air through it. If air does not pass through, this indicates that the water supply tube is frozen. If the water supply tube is frozen, thaw it out. In addition, ensure that the freezer is kept at the proper temperature. The freezer temperature should be kept from 0 to10 degrees Fahrenheit (-18 to -12 degrees Celsius). If the freezer is too cold, the water line may freeze.
Top Solution

03 - Hardwick Refrigerator Water Inlet Valve

The water inlet valve opens to supply water to the dispenser. If the water inlet valve is defective, or if the water pressure is too low, the water valve will not open. The valve requires at least 20psi to function properly. Make sure that the water pressure to the valve is at least 20 psi. If the water pressure is sufficient, use a multimeter to test the water inlet valve for continuity. If the water inlet valve does not have continuity, replace it.
Top Solution

04 - Low Water Pressure from House Supply

The home may have insufficient water pressure. The water inlet valve requires strong water pressure to supply water to the water dispenser. You can check the water flow at the kitchen faucet to help determine if the home's water pressure is sufficient or not.
Highly Likely

05 - Misaligned water filter

Water filter may not be seated properly. Remove and reinstall the water filter. For optimal performance, refrigerator water filters should be replaced every six months or after 200-300 gallons (760-1150 liters) of water have been dispensed - whichever comes first. Replace the water filter if needed.
Highly Likely

06 - Home's water supply valve not fully open

The refrigerator is connected to a water supply valve that may not be fully open. If the water line was disconnected or the valve was shut off for service, it may not have been turned back on to the fully opened position.
Highly Likely

Frequently Asked Questions

Why is my refrigerator water dispenser not working?
How do I test the water inlet valve on my fridge water dispenser?
How can I tell if the water tube in the door is frozen and how do I fix it?
My dispenser is weak or only drips. What should I check?
How do I find the right replacement part on RepairClinic.com for my refrigerator dispenser?