Choose Product
Identify Problem
03
Find Solutions

Frigidaire Refrigerator water dispenser not working

If your Frigidaire water dispenser is not working, start with the parts that fail most often: the dispenser actuator that pushes the switch, a frozen water tube inside the door, or a bad water inlet valve. Those account for most dispenser failures, followed by low house water pressure, a misaligned or overdue water filter, or the home water shutoff valve not fully open. You can often verify a frozen tube by disconnecting the door tube and blowing air through it, and you can check the inlet valve for continuity and the 20 psi minimum pressure it needs to open. Reseat or replace the water filter if it’s seated improperly or past its service life. If you need a replacement actuator, inlet valve, filter or tubing, enter your model number on RepairClinic.com to find the exact replacement part for your refrigerator and get clear instructions and parts that fit your unit.

01 - Frigidaire Refrigerator Dispenser Actuator

The dispenser actuator is the component that activates the switch or switches to send voltage to the dispenser. If the dispenser actuator is damaged, it may be unable to activate the switch. Inspect the dispenser actuator for any damage and replace with a new one if necessary.
Enter model number to search for the required part specific to your product
Top Solution

02 - Water Tube in Door is Frozen

To determine if the water supply tube is frozen, disconnect the tube at the bottom of the door and blow air through it. If air does not pass through, this indicates that the water supply tube is frozen. If the water supply tube is frozen, thaw it out. In addition, ensure that the freezer is kept at the proper temperature. The freezer temperature should be kept from 0 to10 degrees Fahrenheit (-18 to -12 degrees Celsius). If the freezer is too cold, the water line may freeze.
Top Solution

03 - Frigidaire Refrigerator Water Inlet Valve

The water inlet valve opens to supply water to the dispenser. If the water inlet valve is defective, or if the water pressure is too low, the water valve will not open. The valve requires at least 20psi to function properly. Make sure that the water pressure to the valve is at least 20 psi. If the water pressure is sufficient, use a multimeter to test the water inlet valve for continuity. If the water inlet valve does not have continuity, replace it.
Top Solution

04 - Low Water Pressure from House Supply

The home may have insufficient water pressure. The water inlet valve requires strong water pressure to supply water to the water dispenser. You can check the water flow at the kitchen faucet to help determine if the home's water pressure is sufficient or not.
Highly Likely

05 - Misaligned water filter

Water filter may not be seated properly. Remove and reinstall the water filter. For optimal performance, refrigerator water filters should be replaced every six months or after 200-300 gallons (760-1150 liters) of water have been dispensed - whichever comes first. Replace the water filter if needed.
Highly Likely

06 - Home's water supply valve not fully open

The refrigerator is connected to a water supply valve that may not be fully open. If the water line was disconnected or the valve was shut off for service, it may not have been turned back on to the fully opened position.
Highly Likely

Frequently Asked Questions

Why is my Frigidaire refrigerator water dispenser not working?
How do I test the Frigidaire water inlet valve?
How can I tell if the water tube in the door is frozen and how do I fix it?
My dispenser only drips or the water flow is very weak. What should I check?
How do I find and order the correct replacement part on RepairClinic.com?

Shop by Frigidaire Refrigerator Parts